Steve's Extruder Video - Gears & Bearings

greglazor
Posty: 5
Rejestracja: 21 kwie 2018, 4:34

Steve's Extruder Video - Gears & Bearings

Postautor: greglazor » 04 maja 2018, 10:02

Hi,

We watched the Steve's Extruder Head build video. Pretty fun!
In the video, Steve walked away for a bit to get a 11mm socket to press the bearing in. (Either that or he had a quick beer break and the socket was just out of view.)
My wife (in Quality at a major aircraft engine manufacturer) asked whether or not it would be better to use a blow-dryer to heat the gears up a little before pressing the bearing in.
This might do two things:
Avoid accidents, warpage and dents
As the part cools, it might be better seated
Question - before assembly:
Would gentle heating help or hurt?

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://forum.seemecnc.com/viewtopic.php?t=1018
Landing Page Video

Thank you.

phpbb 3.1 themes

Wróć do „Zdjęcia, wideo z biegów”

Kto jest online

Użytkownicy przeglądający to forum: Obecnie na forum nie ma żadnego zarejestrowanego użytkownika i 1 gość